RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: rcmigpilot
Showing results 1 to 9 of 9
Search took 0.01 seconds.
Forum: RC Jets
10-20-2018, 06:57 PM
Replies: 134
Views: 52,354
Posted By rcmigpilot

I can tell you exactly what expect, I have one...

I can tell you exactly what expect, I have one with an original JC Rabbit that puts out 19lbs. Plane came is a just over 22 lbs. We have 700' of grass and with 15 degrees of flap and I seldom take...
Forum: RC Jets
05-09-2018, 07:28 PM
Replies: 134
Views: 52,354
Posted By rcmigpilot

I've got an original 19lb Jet Central Rabbit in...

I've got an original 19lb Jet Central Rabbit in mine. Normal landing is turn upwind and drop the gear after the turn. If all three are down, I turn cross wind at about half runway, and pull the...
Forum: RC Jets
11-16-2017, 03:52 PM
Replies: 134
Views: 52,354
Posted By rcmigpilot

Have you contacted Larry at Boomerang Jets to see...

Have you contacted Larry at Boomerang Jets to see if he will sell you a set?
Forum: RC Jets
05-18-2017, 04:14 AM
Replies: 134
Views: 52,354
Posted By rcmigpilot

I have several dozen flights on mine with an...

I have several dozen flights on mine with an original 19lb thrust Rabbit, nice flying plane with no bad habbits. Only issues I've had have been with the poor quality of the cheap Chinese plywood...
Forum: RC Jets
02-01-2017, 05:04 AM
Replies: 134
Views: 52,354
Posted By rcmigpilot

My elevator to flap mix is easy, none. The only...

My elevator to flap mix is easy, none. The only mix in my plane is rudder to steering. If it balloons when you drop the flaps you're going too fast. Remember, this plane was originally designed by...
Forum: RC Jets
01-31-2017, 08:14 AM
Replies: 134
Views: 52,354
Posted By rcmigpilot

I see one reason you needed more weight to...

I see one reason you needed more weight to balance than mine, I used a smaller air tank and put it under the radio plate, just in front of the fuel tank. It sticks into the inlets a bit but not...
Forum: RC Jets
01-30-2017, 07:31 AM
Replies: 134
Views: 52,354
Posted By rcmigpilot

Your engine is almost a pound heavier than mine...

Your engine is almost a pound heavier than mine so that accounts for some of the weight. I don't remember the exact measurement, but my CG is in the middle of the range so that would probably...
Forum: RC Jets
01-29-2017, 05:35 PM
Replies: 134
Views: 52,354
Posted By rcmigpilot

You might be a little on the high side with...

You might be a little on the high side with weight, but not way out. Mine has 28oz of lead along with two 2600 A123s, and a 2S, 4,000 LiPo pack and is balanced in the middle of the CG range. I'm...
Forum: RC Jets
11-22-2016, 06:30 PM
Replies: 134
Views: 52,354
Posted By rcmigpilot

Put flights 5 and 6 on mine this weekend,...

Put flights 5 and 6 on mine this weekend, original 19 lb Jet Central Rabbit, 23lb dry, 3.5" mains, 2.5" nose wheel on Dreamworks struts and it takes off in half of our 700 grass runway. You've got 4...
Showing results 1 to 9 of 9


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.