RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: nickvenezia
Showing results 1 to 9 of 9
Search took 0.10 seconds.
Forum: RC Warbirds and Warplanes
07-12-2008, 05:58 PM
Replies: 4,089
Views: 800,761
Posted By nickvenezia

RE: TF 1/5 Scale P-51 ARF Assembly (1ST MISHAP!!!)

About your 4 bladed Prop, I wrote earlier and suggested that the 4 Blade 20-8 from Zinger would pull your plane. It will, but the plane does not perform as well as a 22-8 or 10. Mt recommendation is...
Forum: RC Warbirds and Warplanes
06-04-2008, 04:22 PM
Replies: 4,089
Views: 800,761
Posted By nickvenezia

RE: TF 1/5 Scale P-51 ARF Assembly (1ST MISHAP!!!)

Paul,

I flew twice last weekend. I enjoyed flying it but the tail wheel would not come out of the doors because one of my springs came loose. I flew it with gear down and locked. It flew okay...
Forum: RC Warbirds and Warplanes
05-16-2008, 10:25 AM
Replies: 4,089
Views: 800,761
Posted By nickvenezia

RE: TF 1/5 Scale P-51 ARF Assembly (1ST MISHAP!!!)

Here is the link to the prop... http://www.zingerpropeller.com/4_bladed_propeller.htm
Forum: RC Warbirds and Warplanes
05-16-2008, 10:17 AM
Replies: 4,089
Views: 800,761
Posted By nickvenezia

RE: TF 1/5 Scale P-51 ARF Assembly (1ST MISHAP!!!)

Great Job on yours as well. It's nice to see the ghosts of Bill Whisner, and George Preddy are alive and well. As far as the four bladed prop, it is a 20-8 Zinger prop. I will fly first 10 or so...
Forum: RC Warbirds and Warplanes
05-15-2008, 08:47 PM
Replies: 4,089
Views: 800,761
Posted By nickvenezia

RE: TF 1/5 Scale P-51 ARF Assembly (1ST MISHAP!!!)

Thanks for the tip, I did range test. I am using a Spectrum 9303 w/921 and dual receivers (one in front and one in back). I am using a 7.4 Volt 5200Mah battery on the radio equipment. I am using a...
Forum: RC Warbirds and Warplanes
05-15-2008, 07:55 PM
Replies: 4,089
Views: 800,761
Posted By nickvenezia

RE: TF 1/5 Scale P-51 ARF Assembly (1ST MISHAP!!!)

I am just about finished, I have to put the guns and exhaust on I will most likely order the exhaust stacks from Tony Howard, I ran up the engine and found that the low side needle valve was bent to...
Forum: RC Warbirds and Warplanes
04-12-2008, 05:41 PM
Replies: 4,089
Views: 800,761
Posted By nickvenezia

RE: TF 1/5 Scale P-51 ARF Assembly (1ST MISHAP!!!)

Thanks Doug and Cobra1...The springs worked great. Now I am wrestling with the exhaust stacks...I am having the problem of the gap between the fuse and the last exhaust stack..Do either of you have...
Forum: RC Warbirds and Warplanes
04-06-2008, 10:06 AM
Replies: 4,089
Views: 800,761
Posted By nickvenezia

RE: TF 1/5 Scale P-51 ARF Assembly (1ST MISHAP!!!)

Cobra,

Very Nice Job!

You mentioned "springs mounted on the tail wheel to keep it centered when retracted so no hangups when extending". can you give me the link to that process ? I have...
Forum: RC Warbirds and Warplanes
03-19-2008, 07:13 PM
Replies: 4,089
Views: 800,761
Posted By nickvenezia

RE: Scale cockpit - Wow

Can anyone suggest another set of exhaust stacks other than what comes in the kit. Or if not can anyone give some location and mounting advice. With the ARF the stacks extend over the back of the...
Showing results 1 to 9 of 9


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.